Spring Roller Wall Mount Bracket – 2 Buttons

Spring roller wall mount bracket set for hanging a classroom or spring roller map on sheetrock walls. Two steel buttons screw into the wall, and the metal backboard on your map slides right over them.

• Hardware: two round steel mounting buttons, sold as a pair.
• Fit: each button is 1.25 inches wide and matches the standard 1.5-inch C channel on most spring roller backboards.
• How it works: the C channel on the back of the map’s metal backboard slides down over the buttons and rests in place.
• Spacing: place the buttons wherever you like. Setting them 16 or 32 inches apart lines them up with standard wall studs.
• Compatibility: works with single spring roller maps and two-map combos.
• Wall type: made for sheetrock in residential and commercial spaces.
• Common uses: classroom walls, home school rooms, conference rooms, and office training areas.

Teachers and office managers can swap or reposition a map without new drill holes, as long as the backboard uses the same C channel. Pair the buttons with any spring roller map from Map Shop for a clean, low-cost install.